Wireless Sensor Monitoring System: Data calibration function

NiceRF independently developed a wireless network multi-point sensor monitoring system. The system adopts wireless networking mode for temperature, voltage acquisition and real-time monitoring.

Wireless Sensor Monitoring System composition

The wireless network multipoint sensor monitoring system is divided into acquisition terminal and centralized terminal. The modules used in the two parts are the si4463 wireless modules independently developed by NiceRF. Each network consists of a centralized terminal and 64 measurement terminals (expandable to 3000 measurement terminals). The same environment can allow 40 networks to exist simultaneously.

Wireless Sensor Monitoring System: Reason for Data Calibration

When the measurement end collects data, some of the data collected by the sensor will produce some deviation. If the calibration is not performed, the data collected to the server may not be the result we want. Thus, the importance of the data calibration function in the wireless Sensor Monitoring System.

Wireless Sensor Monitoring System: How to operate temperature calibration

First select the corresponding end of the measuring end we need to calibrate.

As shown in the figure, in the red box marked, it is the operation page for data calibration. The Node ID is the ID of the measurement terminal that we need to calibrate. The Temperature Offest is the value to be calibrated. The operation method is as follows: (Assuming the system is a temperature measurement wireless sensor monitoring system, we need to calibrate the measurement end with a Node ID of 1 and the calibration temperature is 30°). We fill in the Node ID and fill in 30 in the Temperature Offes. Finally, click SET to complete the temperature calibration.

Related Article Links:

Wireless Sensor Monitoring System: Fault alarm function

Wireless Sensor Monitoring System: Timed Upload Function Analysis